Hitachi VM-2300A - Page 18

“VCR/CAM”
Select
Switch
“EJECT”
Button
This
switch
changes
the
camera/recorder
to
Operates
with
“POWER”
either
on
or
off,
if
a
the
record
mode
or
to
the
playback
mode.
The»,
power
source
is
connected
to
the
camera/
switch
must
be
in
“CAM”
position
for
“ay,
recorder,
®
recording. ne
“POWER” ON/OFF Switch
camera/recorder on. Slide again to turn
camera/recorder off.
“POWER” light illuminates when “POWER”
ON/OFF switch is slid and camera/recorder is
on.
prsscecnneams:
“POWER” /Dew Indicator Light
Flashing of the light indicates dew conden-
sation on camera/recorder mechanism. While
this light is flashing, the unit will not operate. :
If this occurs, eject the tape and leave the
power on. When the light stops flashing, the
unit can be operated.
“REW” Button
Press this button during stop or fast forward
mode, and fast-rewinding starts. “REWIND”.
indication appears in the viewfinder whenever ¢
the tape counter or time remaining is present.
Press the button during playback of tape, and
the tape is played back in the rewind direction
approximately 3 times faster than the normal
speed to confirm the recorded contents.
Press “PLAY” button to return to normal play-
back mode or press “STOP” button to stop
tape movement.
NOTE: You can also visually scan backward
when the camera/recorder is record/pause
(stand-by) mode by pressing and holding this
button.
“PLAY” Button é
Used for playback of tape recorded in the SP
mode. :
NOTE: When the camera/recorder is record/
pause (stand-by) mode, pressing and holding
this button will play the tape at normal speed.
E18