Hitachi VM-2300A User Manual

m Service Access Door
“MIC” Jack
Connect
an
external
microphone
(Not
supplied)
_ga
here
to
record
sound
from
the
external
micro-
phone.
microphone.
“MIC WIND/NORMAL” Switch
NOTE: Connecting an external microphone
automatically switches off the _ built-in
ssa
This
switch
is
used
to
reduce
noise
that
occurs
MAL position for normal use.
Record Start/Stop Button
recorder. When this button is pressed with
the tape runs to start recording. “REC”
pears in the viewfinder.
and the camera/recorder enters
record/pause (stand-by) mode.
_ Lens Cap Tab
“&y,
Place
the
lens
cap
on
this
tab
when
you
“Hand Strap
Adjust to best fit to your hand.
Open
to
clean
picture
tube
face,
mirror
and
lens.
To
prevent
scratching,
use
a
soft
non
abrasive
cloth
swab
or
lens
cleaning
paper.
'. due to wind. Place the switch in the NOR-
This button is used to control the camera/
the
ssi Camera/recorder set to the recording mode,
ap-
When this button is pressed again, “PAUSE”
appears instead of “REC” and the tape stops
the
are
_ ready to record a scene. The tab also prevents
the lens cap from swinging around on its cord.
‘
E27

Hitachi VM-2300A Specifications

General

Brand	Hitachi
Model	VM-2300A
Category	Camcorder
Language	English