Hitachi VSP 5000 Series - Page 23

7. To send Syslog data to the alternative server (secondary server), select Enable for
Secondary Server and then specify the following items:
■ IP Address
■ Port Number
■ Client Certicate File Name, Password, and Root Certicate File Name
Specify this setting only when New Syslog Protocol (TLS1.2/RFC5424) is
selected for Transfer Protocol.
8. Specify a name you want for Location Identication Name to identify the storage
system.
9. If New Syslog Protocol (TLS1.2/RFC5424) is selected for Transfer Protocol, specify
the values for Timeout, Retry Interval, and Number of Retries.
10. Click Send Test Message to Syslog Server, if necessary, to test the settings.
11. Conrm that the Syslog server received the log message (detailed data: "RefCode:
7FFFFF, This is Test Report.").
12. Click Finish.
13. Conrm the settings in the Conrm window, and then enter the task name in Task
Name.
14. Click Apply.
The task will be registered. If the check box for Go to tasks window for status is
selected, the Tasks window opens.
Editing Syslog settings
Chapter 3: Setting Syslog
Hitachi Alert Notication Guide for VSP5000 Series 23