Hitachi VSP 5000 Series - Changing Trap Notification for SNMP V1 and SNMP V2 C

12. Click Finish.
13. In the Conrm window, enter a name for the task, conrm the settings, and then
click Apply.
Changing trap notification for SNMP v1 and SNMP v2c
This topic describes the procedure to change the IP addresses and communities for trap
notication for SNMP v1 and SNMP v2c.
Before you begin
You must have the Storage Administrator (Initial Conguration) role to perform this task.
For more information, see the System Administrator Guide.
Procedure
1. Display the Device Manager - Storage Navigator main window.
2. From the Settings menu, select Environmental Setting > Edit Alert Settings.
3. Select the SNMP tab.
4. Under SNMP Agent, click Enable.
5. Under SNMP Version, select v1 or v2c.
6. Under Registered Sending Trap Settings, select the trap setting you want to
change, and then click Change.
The Change Sending Trap Setting window opens.
7. If you want to change the Community, select the Community check box, and then
enter a community name or select from the list of existing community names.
You can enter up to 180 alphanumeric characters. The following special characters
are not allowed: ", \, ;, :, ,, *, ?, <, >, |, /, ^, &,', and %.
Do not use a space either at the beginning or the end.
8. If you want to make changes under Send Trap to, select the Send Trap to check
box, and then perform one or more of the following steps:
■ To enter a new IP address, select IPv4 or IPv6, and then enter the IP address.
■ To use an existing IP address, select from the list of existing IP addresses.
■ To add more than one IP address, click Add IP Address to add additional input
elds.
■ To delete an IP address from Send Trap To, click the minus (-) button next to the
IP address.
Note: Any IP address that has all values set to zero (0) cannot be
specied for IPv4 and IPv6. The IPv6 address is specied by entering
eight hexadecimal numbers that are separated by colons (:) using a
maximum of 4 digits from zero (0) to FFFF inclusive. The default form of
the IPv6 address can be specied.
Changing trap notication for SNMP v1 and SNMP v2c
Chapter 4: Setting SNMP
Hitachi Alert Notication Guide for VSP5000 Series 27