Hitachi VSP 5000 Series - Adding Request Authentication for SNMP V3

8. Under Request Permitted, complete one of the following steps:
■ If you want to allow REQUEST operations from all managers, select the All check
box.
■ If you want to allow REQUEST operations only from specied managers, perform
one or more of the following steps:
- To enter a new IP address, select IPv4 or IPv6, and then enter the IP address.
- To use an existing IP address, select from the list of existing IP addresses.
- To add more than one IP address, click Add IP Address to add additional input
elds.
- To delete an IP address from Send Trap To, click the minus (-) button next to the
IP address.
Note: Any IP address that has all values set to zero (0) cannot be
specied for IPv4 and IPv6. The IPv6 address is specied by entering
eight hexadecimal numbers that are separated by colons (:) using a
maximum of 4 digits from zero (0) to FFFF inclusive. The default form
of the IPv6 address can be specied.
9. Click OK
The community and IP address that you entered are added to the Registered
Request Authentication Settings table.
10. Click Finish.
11. In the Conrm window, enter a name for the task, conrm the settings, and then
click Apply.
Adding request authentication for SNMP v3
This topic describes how to add users for SNMP v3 request authentication.
Before you begin
You must have the Storage Administrator (Initial Conguration) role to perform this task.
For more information, see the System Administrator Guide.
Procedure
1. Display the Device Manager - Storage Navigator main window.
2. From the Settings menu, select Environmental Setting > Edit Alert Settings.
3. Select the SNMP tab.
4. Under SNMP Agent, click Enable.
5. Under SNMP Version, select v3.
6. Under Registered Request Authentication Settings, click Add.
Adding request authentication for SNMP v3
Chapter 4: Setting SNMP
Hitachi Alert Notication Guide for VSP5000 Series 31