Hitachi VSP 5000 Series - SNMP Agent MIB Access Mode; Example Object Identifier System; MIB Mounting Specifications Supported by SNMP Agent

MIB Supported?
tcp group No
udp group No
egp group No
snmp group No
Extension MIB Yes
SNMP Agent MIB access mode
The access mode for MIB in all communities is read only. If you send a GET request for a
SET REQUEST operation, you will receive NoSuchName as a RESPONSE.
Example object identifier system
The following gure shows an example object system supported by SNMP Agent.
Execute snmpwalk as follows to obtain all MIB objects:
1. Specify object identier 1.3.6.1.2.1 to obtain the information shown in 1.
2. Specify object identier 1.3.6.1.4.1.116 to obtain the information shown in 2.
MIB mounting specifications supported by SNMP Agent
SNMP Agent supports two MIB mounting specications.
The supported MIB mounting specications are as follows:
■
mgmt OBJECT IDENTIFIER ::= {iso(1) org(3) dod(6) internet(1) 2 }
■
mib-2 OBJECT IDENTIFIER ::= {mgmt 1}
SNMP Agent MIB access mode
Chapter 7: SNMP supported MIBs
Hitachi Alert Notication Guide for VSP5000 Series 45