Hitachi VSP 5000 Series - Testing the SNMP Trap Report

Procedure
1. Display the Device Manager - Storage Navigator main window.
2. From the Settings menu, select Environmental Setting > Edit Alert Settings.
3. Select the SNMP tab.
4. Under SNMP Agent, click Enable.
5. Under SNMP Version, select your SNMP version.
6. Under Registered Request Authentication Settings, select one or more specic
combinations of IP address and community or user, and then click Delete.
7. Click Finish.
8. In the Conrm window, enter a name for the task, conrm the settings, and then
click Apply.
Testing the SNMP trap report
This topic describes the procedure to test the SNMP trap report.
Before you begin
You must have the Storage Administrator (Initial Conguration) role to perform this task.
For more information, see the System Administrator Guide.
Procedure
1. Display the Device Manager - Storage Navigator main window.
2. From the Settings menu, select Environmental Setting > Edit Alert Settings.
3. Select the SNMP tab.
4. Click Send Test SNMP Trap.
Reports the test SNMP trap to the IP address registered in the storage system.
Reports the events registered in the storage system instead of the events that are
set on the SNMP tab. If you want to test the events set on the SNMP tab, click
Finish and apply to the storage system, and then report the test SNMP trap.
5. Verify whether the SNMP trap report (reference code 7f) is received by the SNMP
manager registered in the community.
Testing the SNMP trap report
Chapter 4: Setting SNMP
Hitachi Alert Notication Guide for VSP5000 Series 35