INTRODUCTION
Version 1.0, 02/2015. Copyright 2012 Hitron Technologies
28
Version 1.0, 02/2015. Copyright 2014 Hitron Technologies
28
Hitron CGNVM User’s Guide
1.8 Resetting the CGNVM
When you reset the CGNVM to its factory defaults, all user-configured settings are
lost, and the CGNVM is returned to its initial configuration state.
To reset the CGNVM, click Admin > Device Reset. In the screen that displays, click
the Factory Reset button.
The CGNVM turns off and on again, using its factory default settings.
NOTE: Depending on your CGNVM’s previous configuration, you may need to re-
configure your computer’s IP settings; see IP Address Setup on page 23.
To Next Page
Loading...
