Version 1.0, 11/2016. Copyright 2012 Hitron Technologies
117
Version 1.0, 11/2016. Copyright 2016 Hitron Technologies
117
Hitron CODA-4x8x User’s Guide
The following table describes the labels in this screen.
Table 36: The Admin: IP Passthrough Screen
IP Passthrough Enable Use this to enable or disable IP passthrough.
Click ON to enable IP passthrough.
Click OFF to disable IP passthrough.
IP Passthrough Mode You can configure IP passthrough by LAN port, or
Media Access Control (MAC) address.
Click Port to enable IP passthrough for any device
attached to the LAN ports you specify in the IP
Passthrough Port.
Click MAC to enable IP passthrough for the specific
device whose MAC address you specify in the IP
Passthrough MAC field.
NOTE: If you select MAC and enter a device’s MAC
address, you will not be able to access the
CODA-4x8x’s GUI via the LAN from that device.
In the event you are unable to access the
CODA-4x8x’s GUI, you may need to reset the
CODA-4x8x to its factory default settings.
IP Passthrough Port If you selected Port in the IP Passthrough Mode field,
select the LAN port or ports for which you wish to enable
IP passthrough.
IP Passthrough MAC If you selected MAC in the IP Passthrough Mode field,
enter the MAC address of the device for which you wish
to enable IP passthrough.
Save Changes Click this to save your changes to the fields in this
screen.
Cancel Click this to return the fields in this screen to their last-
saved values without saving your changes.
Help Click this to see information about the fields in this
screen.
To Next Page
Loading...
Need help?
General
