Version 1.0, 11/2016. Copyright 2012 Hitron Technologies
67
Version 1.0, 11/2016. Copyright 2016 Hitron Technologies
67
Hitron CODA-4x8x User’s Guide
DHCP Start IP Use this field to specify the IP address at which the
CODA-4x8x begins assigning IP addresses to devices
on the LAN (when DHCP is enabled).
DHCP End IP Use this field to specify the IP address at which the
CODA-4x8x stops assigning IP addresses to devices on
the LAN (when DHCP is enabled).
NOTE: Devices requesting IP addresses once the
DHCP pool is exhausted are not assigned an IP
address.
Save Changes Click this to save your changes to the fields in this
screen.
Cancel Click this to return the fields in this screen to their last-
saved values without saving your changes.
Help Click this to see information about the fields in this
screen.
Connected Computers
Host Name This displays the name of each network device
connected on the LAN.
IP Address This displays the IP address of each network device
connected on the LAN.
MAC Address This displays the Media Access Control (MAC) address
of each network device connected on the LAN.
Type This displays whether the device’s IP address was
assigned by DHCP (DHCP-IP), or self-assigned.
Interface This displays whether the device is connected on the
LAN (Ethernet) or the WLAN (Wireless(x), where x
denotes the wireless mode; b, g or n).
Status This displays Active when the connected computer is
online, and Inactive when the connected computer is
offline.
Refresh Click this to refresh the information in this section.
Table 14: The Basic: LAN Setup Screen (continued)
To Next Page
Loading...
Need help?
General
