Assembly
17
Assembly instructions
Linear Guideways
GW-04-0-EN-1910-MA
5.2.4.1 Assembling the profile rail without a stop edge
X Mount a block on the reference rail.
Mount the block in accordance with Section 5.4.2.
X Mount a dial gauge on the block.
X Align the dial gauge with a reference edge.
X Move the block a few centimetres along the reference edge in order to align the profile rail.
X Tighten the profile rail’s fixing screws.
X Repeat this process for all fixing points.
X Tighten the fixing screws using a torque spanner to the specified tightening torque.
The reference edge should stretch from the beginning to the very end of the machine bed so that the profile rail
can be aligned across the entire length of the machine bed.
Fig. 5.8 Tensioning using vices
A list of optimum screw tightening torques can be found in Section 12.2 on page 57.
The profile rail has now been assembled.
A list of optimum screw tightening torques can be found in Section 12.2 on page 57.
The profile rail has now been assembled.
Fig. 5.9 Block with mounted dial gauge
To Next Page
Loading...