22
Assembly
Assembly instructions
Linear Guideways
GW-04-0-EN-1910-MA
X Loosen the screw [1].
X Check the results of the pressing process.
X If the cap is not yet fully pressed in, repeat the procedure.
Fig. 5.21 Fully assembled steel or brass bolt cap
The steel or brass cover cap has been mounted.
Table 5.1 Recommended maximum tightening torques for pressing in steel and brass cover caps
Series/Size Bolt cap
Brass Steel Max. tightening torque [Nm]
HG15, RG15 5-001344 — 15
HG20, RG20 5-001350 5-001352 20
HG25, RG25 5-001355 5-001357 20
HG30, HG35, RG30, RG35 5-001360 5-001362 20
HG45, RG45 5-001324 5-001327 85
HG55, RG55 5-001330 5-001332 85
HG65, RG65 5-001335 5-001337 110
Fig. 5.20 Pressing in the cover cap by tightening the screw
The required tightening torque for pressing in the cover caps depends on several factors and can vary consider-
ably. Please observe the specified maximum values in Table 5.1.
[4]
[1]
To Next Page
Loading...