28
Assembly
Assembly instructions
Linear Guideways
GW-04-0-EN-1910-MA
The cover strip has now been mounted.
X Carefully bend the two ends of the cover strip with a rubber mallet (see Fig. 5.35).
5.3.3 Protective caps
To prevent the cover strip lifting up, it is secured at both front sides of the profile rail. There are two different methods of
securing the cover strip:
| Securing the cover strip via steel clamps
| Securing the cover strip via front-side clamping screws
5.3.3.1 Requirements
The profile rail has been mounted.
The cover strip has been mounted.
The block has been mounted.
The cover strip has been secured.
[1]
[2]
Fig. 5.35 Bending the cover strip ends
Fig. 5.36 Placing the steel clamps on the profile rail Fig. 5.37 Mounting the steel clamp
5.3.3.2 Securing the cover strip using steel clamps
X Place the steel clamps [2] on both sides of the profile rail.
X Screw in the allen set screw [1] until the steel clamps are fixed securely.
To Next Page
Loading...