14
1. Slide the outboard end of the boom through the
webbing loop attached to the clew of the mainsail.
2.Connect the boom to the mast using the hinge vertex, clevis pin and split ring.
3. Connect the shackle on the boom outhaul line
to the grommet in the clew of the mainsail.
4. Tie one end of the rotation line to the front of
the clamcleat on top of the boom. Pass the other
end of the line through the end of the rotation
arm on the mast. Take the line back through the
clamcleat.
5. fit a plastic ball stopper at the end.
Boom
To Next Page
Loading...
Need help?
General
