Hobie Tiger - Self-Tacker Traveller Car Control

24
Self tacker traveller
car control
1.
Take the 3mm piece of line and tie it onto the center of
the jib traveller car.
2.
The line then passes through the plastic
pad-eye that is fixed to the spinnaker
pole near the base. This line passes
from the front to back through the pad-
eye.
The line then passes through the black
cleat on the crossbar (lead the line
between the rail and the crossbar) and
tie an 8 figure knot at the end to prevent
the line from falling off.
3.
To adjust the limit of the jib traveller car simply pull or
release the thin line and replace in the cleat once set.