Hobie Tiger - Fully Battened Jib Rigging

21
2.
Then take the 4 m
lang line. Attach
one of the ends to
the block installed
in point 1, lead the
other end through
the block located
on the briddle fix
plate on the hull
and in the last
block of the rigid
forestay. Let the
line pending.
Fully battened jib
1.
Take the jib cunningham
kit. Attach the 2 m
lang line on the dolphin
striker. Lead the free
end through one of the
supplied blocks and fix
it to the jib cleat on the
front crossbar.
3.
Unroll the jib and open the zipper on the luff.
Attach the jib head using the shackle of the white halyard rope. Take the other end of the halyard (with
the small pulley). Then position the jib and the halyard line against the forestay as shown on the pic-
ture. As you pull down on the halyard line close the zipper as the sail is raised.