19
Jib furler (option)
1.
Unroll the jib and open the zipper on the luff. Using the 4mm bow
shackle connect the tack point to the third hole of the stay adjus-
ter.
2.
Shackle the jib head to the jib
halyard. Then position the jib
and the halyard line against
the forestay. Close the zipper
ensuring that the halyard line
remains inside the zipper. As you
pull down on the halyard line
close the zipper as the sail is
raised.
3.
Once the jib is fully raised, take the jib luff tensioner line
and secure it to the bottom holes in the stay adjuster.
4.
Now pass the line through the small pulley at the end of
the jib halyard, then back down through the cleat on the
tack of the jib. Remove the jib halyard line and stow it in
the trampoline pocket.
To use without the jib cunningham, please follow the instruc-
tions 3 & 4 below, otherwise see next page
To Next Page
Loading...
