23
Jib sheet (self-tacker)
1. Attach the middle of the
grey spectra line supplied
to the pad-eye on the spi
pole. Make a knot to fix
the line. Atttach one micro
block to each end of the
spectra.
2. Using the small black
line attached to the tram-
poline pad-eye, pull to get
the jib shock cord out of
the front crossbar. Take the jib sheet out of the
line bag and attach one end to the shock cord
using a tight bowline knot. Let the line go back
inside the crossbar.
3. Take one micro block and fix it to one end of the self tacker spectra line. Take the other end of the
jib sheet and start feeding it through the cam cleat on the crossbar, then through the first micro block
installed at point 1 above, then in the pulley of the white spectra, continue in the other block installed
at point 1, and lastly in the cam cleat on the other side of the crossbar. Lastly, attach the end of the
jib sheet to the other jib shock cord on the other side of the crossbar (same way as at point 2). As a
result, the lines form a W.
4. Take the other end of the white spectra
and lead it through the carbo pulley attached
to the traveller car on the self-tacking track.
5. then passes through the carbo block of the jib
clew and then ties off to the carbo block mounted
on the traveller car. Tie a bowline knot through
the hole in the middle of the pulley.
To Next Page
Loading...
