9
1.
Place the mast onto two supports (eg: two
pieces of polystyrene).
Unroll the trapeze wires and fix them using
a 6 mm shackle to the upper hole on the
mast tang (two on each side).
2.
Unroll the shrouds and the forestay wire +
pigtail + jib halyard rope and fix them to the
lower hole of the mast tang using a shac-
kle 8 mm. The shrouds go onto each side
of the forestay.
3. IMPORTANT : Do not forget to attach the jib halyard rope to the small single block at the end of the
jib halyard wire. Tie off the jib halyard wire and rope near the base of the mast.
Preparation of the mast
To Next Page
Loading...
Need help?
General
