BF15DSBF20D
b.
INSPECTION
FUEL PUMP
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when handling
fuel.
Keep heat, sparks, and flame away.
Handle fuel only outdoors.
Wipe up spills immediately.
I)
Remove the spark plugs from the
No.
1
and
2
cylinder.
2)
Connect the fuel tube from the fuel tank
to
the fuel con-
3)
Disconnect the fuel tube
C
from the fuel chamber.
4)
Squeeze the primer bulb until the fuel reaches
to
the fuel
pump.
Receive the flowing fuel with suitable container.
5)
Turn the camshaft by operating the recoil starter several
times (without electric starter type) or starter motor sever-
al seconds (with electric starter type), and check for fuel
flow.
6)
After inspection, reconnect the fuel tube C
to
the fuel
chamber and make sure that there is no fuel leak.
nector.
c.
INSTALLATION
Before installation check the fuel tubes for deterioration,
1)
Install the fuel connector using the
6
mm special bolt and
cracks, and other damage. Replace if necessary.
6 mm washer.
2)
Apply oil
to
a new O-ring and install it
I
the fuel pump.
3)
Install the fuel pump with the tube joints facing the carbu-
retor side and tighten the 6
x
22
mm flange bolts secure-
ly.
[2]
FUELPUMP
6
x
22
(2)
6-1
9
To Next Page
Loading...
