Honda BF15D - Engine Installation Procedure

BF15DSBF20D
25) Pull out the drain tubes from the oil case and remove the
26)Remove the two 6
x 10 mm dowel pins and oil case gas-
engine from the oil case
ket.
[l] DRAIN TUBE
2. ENGINE INSTALLATION
1) Install the two 6 x 10 mm dowel pins and a new oil case
gasket.
Replace the oil case gasket with new one, when
reassembling.
2) Apply marine grease to the spline of the vertical shaft,
and install the engine by aligning the vertical shaft and
crankshaft.
[l] CRANKSHAF
OIL CASE GASKET