BF15D-BF20D
1.
TILLER HANDLE
a.
REMOVAL
1)
Remove the following:
-
engine cover
(P.
5-1).
-
left engine under cover
(P. 5-2).
2)
Lift the starter case
B
slightly, and disconnect the tube
from the starter case
B
at the carburetor side.
3)
Remove the
6
x
14
mm flange bolt and throttle cable
stay. Disconnect the throttle cable pivot linkage from the
carburetor throttle lever.
4)
Type without electric starter: Remove the emergency
stop switch wire connectors from connector bracket
A
and disconnect them.
Type with electric starter: Remove the starter switch and
emergency stop switch wire connectors from the connec-
tor bracket
A
and disconnect them.
[l]
STARTER CASE B
6x14
THROTTLE CABLE
/I
[11
CONNECTOR
BRACKET A
131
STARTER SWITCH WIRE
(Type with electric starter)
15-2
To Next Page
Loading...
