Honda BF15D - Starter Case B Service

BF15DmBF20D
3. STARTER CASE B
a. REMOVAL
1) Remove the following pars:
- engine cover (P. 5-1).
- Left engine under cover (P. 5-2).
- right engine under cover (P. 5-3).
- recoil starter (P. 7-2).
2)
Pull out the connectors and wires from the holder on the
starter case
B
3) Pull off the breather tube from the clamp on the starter
case
B and remove it. Disconnect the breather tube from
the cylinder head cover.
4) Remove the starter case B with the drain tube attached
by disconnecting the drain tubes from the lower setting
holes.
[l] STARTER CASE B
."
[3] WIRESAND
[4] CONNECTORS
CONNECTORS
\
[41
] BREATHER TUBE
8 x 240 mm
DRAIN TUBE
[3] WATER DRAIN TUBE
I uu i I
b. INSTALLATION
Installation is the reverse order of removal.
See page 2-36 for wires and connectors clamping.
7-1 0