5)
Remove the tilt shaft, tilt arm shaft bracket and tilt arm.
6) Check the tilt lever bushing
B
for wear or damage.
replace if necessary.
7)
Remove and discard the
2
mm cotter pin.
Replace the
2
mm cotter pin with new one when
reassembly. Don't reuse.
8)
Remove the 6 mm washer and reverse lock shaft
B,
then
remove the reverse lock hook and two reverse lock
spring.
9)
Remove and discard the
2
mm cotter pin.
Replace the
2
mm cotter pin with new one when
reassembly. Don't reuse.
10)Remove the
6
mm washer and reverse lock shaft
A
and
reverse lock collar. Disengage the release rod from the
reverse lock arm and remove the reverse lock arm.
TILT SHAFT
BRACKET
TILT LEVER
LOCK
SHAFT
B
(2)
[31
2
mm
COTTER PIN
12-1
2
To Next Page
