a. INSPECTION
The power tilt switch test can be performed with the switch
Check for continuity between the terminals according to the
table below.
There should be continuity between
0-0.
installed on the tiller handle.
1x1
Light green
~
White/black
~
Light blue
1
I
up
1-0
I
I
I
Neutral
I I I
I
b.
REPLACEMENT
1)
Remove the spiral protector, then pull out the switch wires
2)
Remove the
4
x
10
mm self-tapping screws and starter
3)
Remove the power tilt switch from the starter switch hous-
4)
Install a new power tilt switch.
5)
Install the starter switch housing and tighten the
4
x
10
6)
Route the switch wire over the pivot bolt as shown.
7)
Lap the spiral protector around the throttle cable and
tacking care not to damage.
switch housing.
ing.
mm self-tapping screws.
switch wires as shown.
[I
1
SPIRAL
[21
ENGINE
\
BOLT
[3]
POWER TILT
SWITCH WIRE
161
STARTER SWITCH
TILT
SWITCH
15-2
To Next Page
