BF15DoBF20D
10)Set the fuse holder to the fuse holder bracket.
11)Route the charge wire (fuse line) along the main wire har-
ness as shown and wrap the wires with the spiral protec-
tors. Secure the them with the wire band clips.
12)Reinstall the removed parts in the reverse order of
removal.
PI
FUSE HOLDER
11
1
WIRE BAND CLIP
(4)
Replace the wire band with new
one,
if
it has been cut.
After securing the wires with a
new wire band, cut the end of
the wire band as projected
length is about
15
mm
(0.6
in).
r11-1
15
mm
(0.6
in)
r41
SPIRAL PROTECTOR
Wrap the wires with the spiral pro-
tector starting from the branch
Doint of the main harness.
141-1
MAIN WIRE HARNESS
SPIRAL PROTECTOR
131
SPIRAL PROTECTOR
(UPPER)
The starting point of winding must be
5
-
20
mm
(0.2
-
0.8
in) away from the
lower spiral protector.
1616
To Next Page
