Honda BF15D User Manual

4) Remove the five 5 x 10 mm screws attaching the right
engine under cover. Pull the right engine under cover and
disconnect the tubes from the water check grommets
on
the right engine under cover, then remove the right
engine under cover.
5) Place a rag under the oil filter to trap oil leakage.
6) Remove the oil filter using a commercially available oil fil-
ter socket and let the remain oil drain out. Dispose of the
oil filter in a manner that is compatible with the environ-
ment.
7) Apply a thin coat of engine oil to the new oil filter O-ring.
8) Clean the oil filter mounting boss with clean lag, the apply
a thin coat of engine oil to the filter mounting boss.
9) Screw on the new oil filter cartridge by hand until the 0-
ring contacts the filter base, then tighten the oil filter an
additional
718 turn using the oil filter wrench.
TORQUE: 12 N*m (1.2 kgf*m, 8.7 Ibf*ft)
[2]TUBES
[3] RIGHT ENGINE
UNDER COVER
[4] 5 X 10 mm SCREW (5)
' [l] OIL FILTER WRENCH
07HAA-PJ70100
[l]
OIL FILTER CARTRIDGE

Honda BF15D Specifications

General

Displacement	350 cc (21.4 cubic inches)
HP Rating	15 HP
Fuel Delivery	1 Carburetor
Ignition System	Digital CDI
Cooling System	Water Cooled
Gear Ratio	2.08:1
Lubrication	Wet Sump
Gear Shift	F-N-R
Engine Type	4-stroke
Full Throttle RPM Range	5000 - 6000 rpm
Starting System	Manual
Exhaust	Through Propeller
Fuel Tank Capacity	External tank
Oil Capacity	1.1 L
Fuel	Unleaded Gasoline
Shaft Length	15 inches