Honda BF15D - Page 71

7) If the measurements are without the specifications, adjust
as following:
a. Turn the pilot screw in or out
to obtain the standard
b. If the measured value have not yet reached standard,
values using the pilot screw wrench.
inspect and repair the following and recheck.
Dcarbonization from the combustion chamber.
Refacing valve seats and lapping valve and valve seat.
Checking valve stem seal condition.
Checking piston ring conditions.
Disassembling and cleaning the carburetor.
8) After inspection, remove the test equipment and reinstall
the gasket and tighten the cap
to the specified torque.
TORQUE:
5 N*m (0.5 kgfem, 3.6 Ibf*ft)
9) Install the grommet and engine cover.
PILOT (s.]
r21 PILOT SCREW WRENCH
SCREW
L.
07KMA-MS60101
PROBE CAP
' [3] EXTENSION
GROMMET