13
CONTROLS AND FEATURES
CONTROL AND FEATURE IDENTIFICATION CODES
*: Optional equipment
Refer to this chart for an explanation of the Type Codes used in this manual to identify control and feature applications.
TYPE CODE (Example)
Model BF40D BF50D
Type LHA LRTA LRTC LHTC LRTA LRTC XRTA
Shaft Length
L ●●●●●●
X ●
Tiller Handle ●●
Remote Control ●● ●●●
Gas Assist Tilt ●
Power Trim/Tilt ●●●●●●
Tachometer * ●●* ● *
Trim Meter * ●●* ● *
TRL (Trolling) Control Switch * * * * *
Destination: A=American, C=Canadian
T=Power Trim/Tilt
None=Gas Assist Tilt
H=Tiller Handle
R=Remote Control
L=20.5 in (521 mm) (Long Shaft)
X=24.5 in (622 mm) (Extra Long Shaft)
LRTA
31ZZ46240.book Page 13 Tuesday, July 22, 2014 10:00 AM
To Next Page
Loading...
