57
OPERATION
STOPPING THE ENGINE
Emergency Engine Stopping
LH and LHT Types
(tiller handle)
LRT and XRT Types
(remote control)
To stop the engine in an emergency,
pull the emergency stop switch clip
out of the emergency stop switch by
pulling the emergency stop switch
lanyard.
We suggest that you stop the engine
this way occasionally to verify that
the emergency stop switch is
operating properly.
Turn the ignition switch key to the
OFF position after verifying the
emergency stop switch operation.
EMERGENCY STOP SWITCH
EMERGENCY STOP
SWITCH LANYARD
EMERGENCY STOP
SWITCH CLIP
PULL
EMERGENCY STOP SWITCH
EMERGENCY STOP
SWITCH LANYARD
EMERGENCY STOP
SWITCH CLIP
PULL
31ZZ46240.book Page 57 Tuesday, July 22, 2014 10:00 AM
To Next Page
Loading...
