Honda BFP8D - Remote Control (Standard or Optionally Applicable Equipment)

52
OPERATION
6. (Manual choke type)
If the choke knob was pulled to the
ON position to start the engine,
gradually push it to the OFF
position as the engine warms up.
Also, as the engine warms up, the
throttle grip can be turned to the
SLOW position without stalling.
7. Before getting underway, allow the
engine to warm-up sufficiently to
ensure good performance.
During the warm-up period, check
the oil pressure indicator (p. 33)
and cooling system indicator
(p. 34).
If the indicators show any
abnormal condition, immediately
stop the engine and determine the
cause of the problem. Refer to
TAKING CARE OF
UNEXPECTED PROBLEMS,
on p. 107.
Remote Control
(standard or optionally applicable
equipment)
For panel-mount or top-mount remote
control information, refer to the
instructions provided with the remote
control equipment.
1. Put the emergency stop switch clip
in the emergency stop switch, and
attach the emergency stop switch
lanyard securely to the operator or
to the operator’s PFD (Personal
Flotation Device).
The engine will not start or run,
unless the emergency stop switch
clip is in the emergency stop
switch.
The emergency stop switch clip
and emergency stop switch lanyard
system is a safety device that will
stop the engine if you fall away
from the controls while operating
the boat.
Always attach the emergency stop
switch lanyard securely to the
operator or to the operator’s PFD
before starting the engine.
EMERGENCY STOP
SWITCH
EMERGENCY STOP
SWITCH CLIP
EMERGENCY STOP
SWITCH LANYARD
31ZY06520.book Page 52 Friday, October 13, 2023 1:58 PM