Honda NU50 - Engine Removal Procedure

ENGINE REMOVAL/INSTALLATION
ENGINE REMOVAL
Remove the rcar brake adjusting nut.
Remove the rear shock absorber mounting nut, and
bolt with the rear brake cable setting plate.
Rp.move the battery ilnd battery holder.
Remove the carburetor cap and pull the throttle
villve out. Disconnect the throttle cable from the
throttle valve and remove the return spring, car-
buretor cap and rubber seal.
Disconnect the oil pump control cable.
Turn the fuel valve OFF and drain the fuel from the
carburetor.
Disconnect th!! fuel liM:H the carburewr.
fA' 'dili!ii!i' -,
'
I .
Keep ga.sofi"e away from flames Of ~pa'ks.
Wipe lip ~'[Jilled gasolille (/1 ol/ce.
DiSCOI)IH!Ct the oil inlet tube at the oil pump.
MOUNTING BOLT
~HONDA
~NU50.NU50M
REAR BRAKE CAGLE
SETTING PLATE
REAR BRAKE CABLE
ADJUSTER
OIL PUMP CONTROL CABLE
1
.. ,-.. ')J
. •.. 'm ~
.1
<,
Disconnec.t the starlet wir!! coupler and alternJlor
wire connectors.
Remove the starter and altClIlator wires from the
frame clamp.
CARBURETOR CAP
FUEL LINE OIL INLET
TUBE
5-2
STARTER WIRE
COUPLER
48
ALTERNATOR
WIRE CONNECTORS
Date of hsue: Nov.. 1981
© HONDA MOTOR CO., LTO