Honda NU50 - Driven Face Assembly; Driven Pulley Assembly

DRIVE PULLEY/KICK STARTER/CLUTCH/DRIVEN PULLEY
GUIDE ROLLER PIN
DRIVEN FACE ASSEMBLY
Install the movable driven face, guide roller, guide
roller pin, oil seals and O·rings.
NOTE
Apply 4.0 ~ 4.59 (0.14 - 0.'6 oz.) of grease 10
the areas shown.
Slide
the seal collar onto the movable driven face.
~HONDA
~ NU50· NU50M
GUIDE ROLLER
a-RINGS __ OIL SEAL
SEAL COLLAR
CLUTCH SPRING COMPRESSOR
07960-1870000
DRIVEN PULLEY ASSEMBLY
Position the driven face assembly. spring and drive
plate assembly on the clutch spring compressor.
Compress the spring by turning the handle while
aligning the flat faces of the driven face and drille
plate.
8-22
88
Date of Issue. Nov., 1981
©HONDA MOTOA CO" LTD.