4 - 43
Two Discrete Lengths (Parameter L2)
This option decodes only those codes containing two selected lengths. For example, when you want to scan only
D 2 of 5 symbols containing 2 or 14 characters, scan the “D 2 of 5 Two Discrete Lengths” bar code and then “0”,
“2”, “1” and “4” bar codes using the Keypad Number Symbols (page 4-72).
To begin setting two discrete lengths, scan this bar code:
Next, scan four numeric bar codes that correspond to the desired value. Single digit numbers must have a leading
zero. If you wish to change your number selection, scan Cancel on the Keypad Number Symbols page.
Length Within Range
This option decodes a code type within a specified minimum and maximum range. For example, when you want
to scan only D 2 of 5 symbols containing between 4 and 12 characters, scan the “D 2 of 5 Length Within Range”
bar code and then “0”, “4”, “1” and “2” bar codes using the Keypad Number Symbols (page 4-72).
To begin setting lengths within a range, scan this bar code:
Next, scan numeric bar codes that correspond to the desired value. Single digit numbers must have a leading
zero. If you wish to change your number selection, scan Cancel on the Keypad Number Symbols page.
Any Length
This option decodes D 2 of 5 bar codes containing any number of characters.
Note: Important: Selecting this option may lead to misdecodes for D 2 of 5 codes.
To set any length, scan this bar code:
To Next Page
Loading...
