3 - 2
Restore Factory Defaults
Scan this bar code to restore factory defaults in the Bluetooth Ring Scanner module.
Module Firmware Version
1. Connect the Bluetooth Ring Scanner module to a host device with a video display. Bluetooth Ring Scanner must be
fully assembled (battery, ring decoder).
2. If necessary, open a text editor on the host device, make sure the cursor is in the open file, then scan this bar code.
Scan this bar code, with either the ring scanner or the ring imager, to view the firmware version of the Bluetooth Ring Scan-
ner module on the host device display.
Restore Factory Defaults
Module Firmware Version
To Next Page
Loading...
