5 - 55
Length Within Range
This option decodes a code type within a specified minimum and maximum range. For example, when you want to
scan only D 2 of 5 symbols containing between 4 and 12 characters, scan the “D 2 of 5 Length Within Range” bar code
and then “0”, “4”, “1” and “2” bar codes using the Imager Keypad Number Symbols (page 5-81).
To begin setting lengths within a range, scan this D 2 of 5 Length Within Range bar code:
Next, scan numeric bar codes that correspond to the desired value. Single digit numbers must have a leading zero. To
correct an error or to change a selection, scan Cancel on the “Imager Keypad Number Symbols” page.
Any Length
This option decodes D 2 of 5 bar codes containing any number of characters.
Selecting this option may lead to misdecodes for D 2 of 5 codes. See next note.
To set any length, scan this D 2 of 5 Any Length bar code:
Note: Due to the construction of the D2 of 5 symbology, it is possible for a scan line covering only a portion of the code
to be interpreted as a complete scan, yielding less data than is encoded in the bar code. To prevent this, select
specific lengths (using D2 of 5 – One Discrete Length and D 2 of 5 Two Discrete Lengths) for D 2 of 5 applications.
To Next Page
Loading...
