Honeywell 8650 - Suffix 2; Scan Data Transmission Format

4 - 9
Next, scan four numeric bar codes that correspond to the computer keycode using the Keypad Number Symbols (page
4-72).
If you wish to change your selection, scan Cancel on the Keypad Number Symbols page.
Suffix 2
To begin setting Suffix 2 value, scan this bar code:
Next, scan four numeric bar codes that correspond to the computer keycode using the Keypad Number Symbols (page
4-72).
If you wish to change your numeric selection, scan Cancel on the Keypad Number Symbols page.
Scan Data Transmission Format
Note: Parameter Prefix and Suffix (page 4-8) should be set after setting this parameter.
Use this option when you want to append a prefix and suffix to the decode data.
Set this parameter by scanning one of the following bar codes.
* Data As Is
[Data] [Suffix 1]
[Data] [Suffix 2]