4 - 64
User-Programmable Supplementals
When Supplemental User-Programmable option is selected from Decode UPC/EAN Supplementals, select User-
Programmable Supplemental 1 to set the 3-digit prefix. Then select the 3 digits using the Keypad Number
Symbols (page 4-72).
User-Programmable Supplemental 1
User-Programmable Supplemental 2
When Supplemental User-Programmable option is selected from Decode UPC/EAN Supplementals, select User-
Programmable Supplemental 2 to set the 3-digit prefix. Then select the 3 digits using the Keypad Number
Symbols (page 4-72).
Decode UPC/EAN Supplemental Redundancy
Default: 7 Times
With Autodiscriminate UPC/EAN Supplementals selected, this option adjusts the number of times a symbol
without supplementals will be decoded before transmission. The range is from 2 to 20 times. Five or above is
recommended when decoding a mix of UPC/EAN symbols with and without supplementals, and the
autodiscriminate option is selected.
To begin setting the decode redundancy value, scan this bar code:
Next, scan two numeric bar codes that correspond to the desired value using the Keypad Number Symbols (page
4-72). Single digit numbers must have a leading zero.
If you wish to change your selection, scan Cancel on the Keypad Number Symbols page.
Smart Supplemental Plus User Programmable 1
and 2
To Next Page
Loading...
