Honeywell 8650 - Page 5

iii
Bi-Directional Redundancy ............................................................................................ 4-7
Disable All Symbologies ................................................................................................ 4-8
Data Options........................................................................................................................ 4-8
Prefix and Suffix............................................................................................................. 4-8
Prefix........................................................................................................................ 4-8
Suffix 1..................................................................................................................... 4-8
Suffix 2..................................................................................................................... 4-9
Scan Data Transmission Format ................................................................................... 4-9
Transmit Code ID Character........................................................................................ 4-11
Transmit No Code ID Character ............................................................................ 4-11
Transmit Symbol Code ID Character..................................................................... 4-11
Transmit AIM Code ID Character .......................................................................... 4-12
Laser On Time............................................................................................................. 4-14
Linear Code Type Security Level (Redundancy Level) ............................................... 4-15
Parameter Pass Through............................................................................................. 4-16
Parameter Scanning.................................................................................................... 4-16
Power Mode................................................................................................................. 4-17
Scan Angle (SE955 only)............................................................................................. 4-17
Simple Serial Interface (SSI) Options.......................................................................... 4-18
SSI Defaults........................................................................................................... 4-18
Beep on BEL.......................................................................................................... 4-18
Baud Rate.............................................................................................................. 4-18
Decode Data Packet Format ................................................................................. 4-19
Host Character Time-out ....................................................................................... 4-19
Intercharacter Delay .............................................................................................. 4-20
Software Handshaking........................................................................................... 4-22
Stop Bit Select ....................................................................................................... 4-23
Time-out Between Decodes, Same Symbol................................................................ 4-23
Transmit “No Read / Decode” Message ...................................................................... 4-24
Trigger Mode ............................................................................................................... 4-25
Scanner Parameters – Bar Code Type Specific................................................................ 4-26
Chinese 2 of 5.............................................................................................................. 4-26
Codabar....................................................................................................................... 4-27
CLSI Editing........................................................................................................... 4-27
NOTIS Editing........................................................................................................ 4-28
Set Lengths for Codabar........................................................................................ 4-28
One Discrete Length (Parameter L1) .............................................................. 4-28
Two Discrete Lengths (Parameter L2) ............................................................ 4-29
Length Within Range ...................................................................................... 4-29
Any Length ...................................................................................................... 4-29
Code 11 ....................................................................................................................... 4-30
Set Lengths for Code 11........................................................................................ 4-30
One Discrete Length (Parameter L1) .............................................................. 4-30
Two Discrete Lengths (Parameter L2) ............................................................ 4-30
Length Within Range ...................................................................................... 4-31
Any Length ...................................................................................................... 4-31
Code 11 Check Digit Verification ........................................................................... 4-32
Transmit Code 11 Check Digits ............................................................................. 4-32