12/00 UDC3300 Basic Model: DC33XB User Manual v
Tables
Table 1-1 Function of Keys ____________________________________________________2
Table 2-1 Permissible Wiring Bundling ___________________________________________5
Table 2-2 Input 2 Jumper Selections _____________________________________________9
Table 2-3 Control Relay Contact Information______________________________________17
Table 2-4 Alarm Relay Contact Information_______________________________________17
Table 3-1 Configuration Procedure _____________________________________________21
Table 3-2 Tuning Group Function Prompts _______________________________________22
Table 3-3 SP Ramp Function Prompts __________________________________________24
Table 3-4 Accutune Group Function Prompts _____________________________________26
Table 3-5 Algorithm Group Function Prompts _____________________________________26
Table 3-6 Output Algorithm Group Function Prompts _______________________________28
Table 3-7 Input 1 Group Function Prompts _______________________________________29
Table 3-8 Input 2 Group Function Prompts _______________________________________30
Table 3-9 Control Group Function Prompts_______________________________________31
Table 3-10 Options Group Function Prompt ______________________________________33
Table 3-11 Communications Group Function Prompts ______________________________34
Table 3-12 Alarms Group Function Prompts ______________________________________36
Table 3-13 Display Group Function Prompts______________________________________38
Table 4-1 Lower Display Key Parameter Prompts__________________________________40
Table 4-2 Error Messages ____________________________________________________41
Table 4-3 Procedure for Starting Up the Controller _________________________________42
Table 4-4 Setpoint Selection Indication __________________________________________44
Table 4-5 Procedure for Selecting Two Sets of Tuning Constants _____________________44
Table 4-6 Procedure for Setting Switchover Values ________________________________44
Table 4-7 Procedure for Setting Tuning Constant Values ____________________________45
Table 4-8 Procedure for Switching PID SETS from the Keyboard _____________________45
Table 4-9 Procedure for Displaying or Changing the Alarm Setpoints __________________46
Table 4-10 Procedure for Displaying the 3PSTEP Motor Position______________________46
Table 4-11 Digital Input Option Action on Contact Closure ___________________________48
Table 4-12 Digital Input Combinations “DIG IN1” or “DIG IN2” ________________________49
Table 4-13 Procedure for Starting TUNE (Demand) Tuning __________________________51
Table 4-14 Procedure for Using TUNE at Start-up for Duplex_________________________52
Table 4-15 Procedure to Enter a Security Code ___________________________________52
Table 5-1 Procedure for Running a Setpoint Ramp_________________________________54
Table 5-2 Program Contents __________________________________________________56
Table 5-3 Run/Monitor Functions_______________________________________________60
Table 9-1 Calibration Procedure _______________________________________________70
To Next Page
Loading...
