Dolphin CN80 Mobile Computer 9
Charge the Battery Before Use
Dolphin CN80 computers ship with a partially charged battery. Fully charge the
battery before using your computer for the first time.
Note: CN80G model battery ships separately from the mobile computer.
You can charge the battery with a Dolphin CX80 series charging accessory before
or after you install the battery in the computer. A fully discharged battery charges
in approximately 4 hours.
Note: Honeywell recommends using Honeywell accessories and power adapters. Using
non-Honeywell accessories or power adapters may cause damage not covered by the
warranty.
To charge the battery before you install it in the computer:
• Insert the battery into the CX80 Quad Battery Charger or the battery well of a
Home Base or Ethernet Home Base.
To charge the battery after installing it in the computer:
• Insert the computer into a CX80 Home Base, Ethernet Home Base, Charge Base,
Net Base, Snap-on Adapter, or Vehicle Power Adapter.
Note: Using the computer while charging the battery increases the time required to reach
a full charge.
Replace the Battery
If your battery power is low, you need to either charge the battery in the computer,
or replace it with a charged battery.
To replace the battery:
1. Save your files and close any open applications.
2. Press and hold the Power button until the options menu appears.
3. Tap Battery swap. Follow the on-screen instructions to place the unit in battery
swap mode.
Warning: Ensure all components are dry prior to mating the computers
and batteries with peripheral devices. Mating wet components
may cause damage not covered by the warranty.
Warning: If you have a CN80 NI/CN80G model certified for use in
hazardous locations, read About the optional Dust Cover,page
7.
To Next Page
Loading...
