26 Dolphin CN80 Mobile Computer
•If you enabled Preemptive Heating, the heater Preemptive delay time stops
when the icons are used to turn the heater On or Off.
How Manual Mode Works
Manual mode gives you full control over turning the heaters On or Off.
When Manual mode is enabled, automatic cold storage enter/exit detection is no
longer used to control the heater behavior. To turn the heaters on/off, you must tap
a button on the Heater screen in the Settings app. Full power is used for defrosting.
Manual mode is disabled by default.
Turn Manual Mode On/Off
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings > Heater.
3. Tap the Automatic/Manual button to switch between the Automatic or Manual
mode. The active mode appears on the button. When Manual mode is enabled,
the Heater On/Heater Off button next to the mode button is active.
4. Tap the Heater On/Heater Off button to control the heaters.
Configure the Heater in the Settings App
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings > Heater.
3. Modify the heater parameters.
4. Tap Update to apply the changes.
5. Tap OK.
Heater Parameters
You can configure the following Heater parameters in the Settings app to fit your
specific application environment.
Heater Setting Description
Heater Enable or Disable the Heater feature and temperature monitoring.
Tap the switch button at the top of the screen to toggle the feature
On or Off. The default is On.
Turn heater on when the
temperature has changed by
Set the sensitivity of the cold storage exit trigger by defining a
DeltaT value. To detect a cold storage exit, the computer looks for a
quick rise in temperature (°C), over a brief period of time. The default
DeltaT value is 0.5°C.
To Next Page
Loading...
