Programming
70 MS-9050UD PN 52413:C 01/23/08
If the selected address corresponds to a control module, a screen displaying information about
the control module with the selected address will be displayed as shown in "Edit Module
Screen for Control Modules" on page 77.
If the selected address corresponds to a monitor
module, a screen displaying information about
the module with the selected address will be displayed as illustrated in the following:
See Page
NORMAL MONITOR
<ADJ><NOUN>
ZNNN
1M012
EDIT MONITOR 1M012
1=ENABLED YES
2=TYPE MONITOR
Edit Monitor Screen #2
EDIT MONITOR 1M012
1=PRE-SIGNAL NO
Edit Monitor Screen #3
EDIT MONITOR 1M012
1=WALKTEST YES
2=ZONE ASSIGNMENT
00 ** ** ** **
Edit Monitor Screen #4
EDIT MONITOR 1M012
1=ADJECTIVE/NOUN
2=DESCRIPTION
********************
Edit Monitor Screen #5
To Next Page
Loading...
