Honeywell HH492 - MSI Message Length

HH492 User Guide 87
When Check Character is set to Validate Type 10/11, but Don’t Transmit, the unit
will only read MSI barcodes printed with the specified type check character(s), but
will not transmit the check character(s) with the scanned data.
MSI Message Length
Scan the barcodes below to change the message length. Refer to Message Length
Description (page 58) for additional information. Minimum and Maximum
lengths = 4-48. Minimum Default = 4, Maximum Default = 48.
* Validate Type 10, but Don’t
Transmit
Validate Type 10 and Transmit
Validate 2 Type 10 Characters,
but Don’t Transmit
Validate 2 Type 10 Characters
and Transmit
Validate Type 11 then Type 10
Character, but Don’t Transmit
Validate Type 11 then
Type 10 Character and Transmit
Disable MSI Check Characters
Minimum Message Length
Maximum Message Length