HH492 User Guide 13
INPUT/OUTPUT SETTINGS
Power Up Beeper
The scanner can be programmed to beep when it’s powered up. Scan the Off
barcode(s) if you don’t want a power up beep. Default = Power Up Beeper On -
Scanner.
Beep on BEL Character
You may wish to force the scanner to beep upon a command sent from the host. If
you scan the Beep on BEL On barcode below, the scanner will beep every time a
BEL character is received from the host. Default = Beep on BEL Off.
Power Up Beeper Off -
Scanner
* Power Up Beeper On -
Scanner
To Next Page
Loading...
