Honeywell HH492 - Code 39 Message Length; Code 39 Append

62 HH492 User Guide
When Check Character is set to Validate and Transmit, the scanner only reads
Code 39 barcodes printed with a check character, and will transmit this character
at the end of the scanned data. Default = No Check Character.
Code 39 Message Length
Scan the barcodes below to change the message length. Refer to Message Length
Description (page 58) for additional information. Minimum and Maximum
lengths = 0-48. Minimum Default = 0, Maximum Default = 48.
Code 39 Append
This function allows the scanner to append the data from several Code 39
barcodes together before transmitting them to the host computer. When the
scanner encounters a Code 39 barcode with the append trigger character(s), it
buffers Code 39 barcodes until it reads a Code 39 barcode that does not have the
append trigger. The data is then transmitted in the order in which the barcodes
were read (FIFO). Default = Off.
* No Check Character
Validate, but Don’t Transmit
Validate and Transmit
Minimum Message Length
Maximum Message Length
On
* Off