100 HH492 User Guide
Aztec Append
This function allows the scanner to append the data from several Aztec barcodes
together before transmitting them to the host computer. When the scanner
encounters an Aztec barcode with the append trigger character(s), it buffers the
number of Aztec barcodes determined by information encoded in those barcodes.
Once the proper number of codes is reached, the data is output in the order speci-
fied in the barcodes. There are 3 ways to scan appended Aztec Code:
• One scan—Pull the trigger one time and all appended Aztec Codes in the same
image are decoded
• Swipe—Pull and hold down the trigger and scan all appended Aztec Codes while
keeping the trigger pressed. The scanner emits short beeps for each partial
Aztec Code that is scanned and buffered. One long beep is emitted after the last
Aztec Code is scanned and the data is complete. Not compatible with
Presentation mode.
• Point and shoot—Pull the trigger one time for each image. The scanner emits a
short beep for each partial Aztec Code that is scanned and buffered. One long
beep is emitted after the last Aztec Code is scanned and the data is complete.
Not compatible with Presentation mode.
Default = One Scan.
Aztec Code Page
Aztec Code pages define the mapping of character codes to characters. If the data
received does not display with the proper characters, it may be because the
barcode being scanned was created using a code page that is different from the
one the host program is expecting. If this is the case, scan the barcode below,
select the code page with which the barcodes were created (see ISO 2022/ISO 646
To Next Page
Loading...
