HH492 User Guide 109
UTILITIES
To Add a Test Code I.D. Prefix to All Symbologies
This selection allows you to turn on transmission of a Code I.D. before the decoded
symbology. (See the Symbology Charts, beginning on page 121 for the single
character code that identifies each symbology.) This action first clears all current
prefixes, then programs a Code I.D. prefix for all symbologies. This is a temporary
setting that will be removed when the unit is power cycled.
Show Software Revision
Scan the barcode below to output the current software revision, unit serial number,
and other product information for both the scanner and base.
Test Menu
When you scan the Test Menu On code, then scan a programming code in this
manual, the scanner displays the content of a programming code. The
programming function will still occur, but in addition, the content of that
programming code is output to the terminal.
Note: This feature should not be used during normal scanner operation.
Add Code I.D. Prefix to
All Symbologies (Temporary)
Show Software Boot Revision
To Next Page
Loading...
