HH492 User Guide 7
CORDLESS SYSTEM OPERATION
How the Cordless Communication Base Works
A cordless charge base provides the link between the cordless scanner and the
host system. The base contains an interface assembly and an RF communication
module. The RF communication module performs the data exchange between the
cordless scanner and the interface assembly. The control assembly coordinates
the central interface activities including: transmitting/receiving commands and
data to/from the host system.
Link the Scanner to a Communication Base
Turn off power before connecting a base, then power up the computer once the
base is fully connected. When the base is connected and powered up, use the
scanner to scan the 2D MAC address code on the bottom of the base. The green
LED on the scanner flash and two beeps when connected successfully.
Unlink/Replace a Linked Scanner
If you need to replace a broken or lost scanner that is linked to a base, scan the
Unlink Scanner barcode to unlink the scanner. Use the new scanner to scan the 2D
MAC barcode on the bottom of the base to start a new link.
To Next Page
Loading...
