HH492 User Guide 11
Reset Scanner
Scanning this barcode reboots the scanner and causes it to relink with the base or
Access Point.
Batch Mode
Batch mode is used to store barcode data when a scanner is out of range of its
base, or when performing inventory. The data is transmitted to the base once the
scanner is back in range.
Note: Batch Mode is only supported by the Honeywell Communication Base (CCB).
Automatic Batch Mode stores barcode data when the scanner is out of range of
the base. The data is automatically transmitted to the base once the scanner is
back in range. When the scanner’s buffer space is full, any barcodes scanned
generate an error tone. In order to scan barcodes again, the scanner must be
moved back into range of the base so data can be transmitted.
Default = Batch Mode Off.
Green, off Base has no power input
LED Indications Cause
To Next Page
Loading...
